The Setup LRMs window contains two panes: the LRSs pane and the Columns pane. These panes are described in the following sections.
The LRSs pane shows the base reference system (as denoted by a shadow check mark in the Basic LRS? column) along with a record for each alternate location reference method (LRM). The text entered in the Loc Ref Name column in the LRSs pane is what will appear in the drop-down list in the Location Reference field on the side of the browser window.
Each reference system is assigned a type in the LRS Type column, with the type being selected from a drop-down list. The list provides the following selections:
Use Location Across: This selection means that for this reference system the identification of a position laterally (for example, across the road) will be done using the two columns Lane Direction and Lane Number. (These two columns are pre-defined in the system, and appear in various windows throughout the system as indicated in the table below.)
Note: The Base LRM is always set to "Use Location Across," thus providing the capability of lateral positioning, which can then be employed (if desired) for a particular system implementation. |
Window Type/Situation | What Occurs When "Use Location Across" Is Selected for an Alternate LRM | What Occurs When "Ignore Location Across" Is Selected for an Alternate LRM |
---|---|---|
In the Alternate LRM Definition window. | The Lane Direction column is shown. | No lateral indication columns are shown. |
In any location-referenced window when an alternate LRM is selected in the Location Reference field. | The Lane Direction and Lane Number columns are shown. | No lateral indication columns are shown. |
In any location-referenced window when the base LRM is selected in the Location Reference field. | The Lane Direction and Lane Number columns are shown. | The Lane Direction and Lane Number columns are shown. (This is because the base LRM is always set to "Use Location Across.") |
When you right-click an alternate LRMs in the upper pane, the system displays the following special command in a shortcut menu:
Note: The values set in this pane for the base LRM should never be changed without first consulting AgileAssets.
The Columns pane shows the columns that define the reference system selected in the upper pane. The following columns appear in this pane:
Show "To"?: If the check box in this column is checked, then this LRM field will be shown twice in any location-referenced window when an alternate LRM is selected. It is shown once for the "from" point and then again for the "to" point. If clear, then the LRM field appears once and applies to both "from" and "to" points.
Note: This column must be checked for the column designated "location measure." |